| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| Machine Shop for Cylinder Boring/Honing http://www.kawi2strokes.com/forum/viewtopic.php?f=14&t=14473 |
Page 1 of 1 |
| Author: | tonyh_2222 [ Fri May 21, 2021 9:16 pm ] |
| Post subject: | Machine Shop for Cylinder Boring/Honing |
Does anyone have a good machine shop you'd recommend who's got experience with triple cylinders/head work in NC or upstate SC? Prefer in Charlotte area or within a couple hour drive. |
|
| Author: | Jim [ Fri May 21, 2021 9:35 pm ] |
| Post subject: | Re: Machine Shop for Cylinder Boring/Honing |
It's not as close as you want, but T-Hoff in Raleigh did a good job for me at a reasonable price. |
|
| Author: | tonyh_2222 [ Fri May 21, 2021 9:40 pm ] |
| Post subject: | Re: Machine Shop for Cylinder Boring/Honing |
Thanks Jim! |
|
| Author: | Jim [ Fri May 21, 2021 9:53 pm ] |
| Post subject: | Re: Machine Shop for Cylinder Boring/Honing |
You might ask Mark Haase. He lives near Charlotte I believe. He's here as "m in sc" and on 2-stroke world with the same board name, as I remember. |
|
| Author: | rngdng [ Mon May 24, 2021 11:23 am ] |
| Post subject: | Re: Machine Shop for Cylinder Boring/Honing |
Cycle Engineering in Waterloo SC (near Laurens) does all of my work. He's done H1, GT750, TS400, DT400 for me. Call James at 864-677-4630. James Shinault is a great guy and will treat you right. Tell him Lane sent you. James does cylinder boring, but I don't think he does head work. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|