Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
check valves sticking on oil lines? http://www.kawi2strokes.com/forum/viewtopic.php?f=14&t=14238 |
Page 1 of 1 |
Author: | h2smokin [ Mon Aug 24, 2020 9:56 pm ] |
Post subject: | check valves sticking on oil lines? |
So my h2 had been sitting for about 4 years now, at least since 2016. While overseas motor would get rotated occasionally just to keep it free. I removed carbs the other day trying to go through carbs prior to starting . The bowls on each carb were full of oil. I assume they filled as the oil slowly flowed thru the pump as no other way for it to get there. It is a 75 H2. Are there check valves in the oil feed lines to the carbs? If so can they be pulled out and cleaned? Also I assume there may be valves in the line that goes to the crank? Bike itself fired right up once i cleaned the oil out. Was some smoke but not to much and it seemed to idle well. I did not ride it as there is no front brake currently so not sure how it is going down the road. Anywhere to get parts if needed? I may have a new 3to1 for the crank at least. Thanks |
Author: | mraxl [ Mon Aug 24, 2020 10:27 pm ] |
Post subject: | Re: check valves sticking on oil lines? |
Kaw p/n 16128-009 Hodaka p/n 993713 Both of the above are replacement check valves for carb oil lines. |
Author: | h2smokin [ Wed Aug 26, 2020 9:24 pm ] |
Post subject: | Re: check valves sticking on oil lines? |
Thanks for the info |
Page 1 of 1 | All times are UTC - 5 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |