Kawi2strokes.com Forum
http://www.kawi2strokes.com/forum/

Counter shaft o ring / seal
http://www.kawi2strokes.com/forum/viewtopic.php?f=14&t=13455
Page 1 of 1

Author:  demus [ Sun Jun 17, 2018 6:20 pm ]
Post subject:  Counter shaft o ring / seal

Ok so now that my H2 leans WAY over on the side stand because of all the mods I have done the counter shaft leaks a bit.
Sitting straight up its fine, no leaks , on the side stand it weeps a bit.
Two questions.
Will this stop if I change the o ring to a new one?

Should I just live with it and clean up the mess once and a while?

The bike rest straight up in the garage so this is only happening when I go out for a ride and leave it parked for a bit. But it dont take much time to start to drip.

I watch the fluids so I am not worried about that either.

Author:  Ja-Moo [ Sun Jun 17, 2018 6:40 pm ]
Post subject:  Re: Counter shaft o ring / seal

It's "might", but most likely it's the collar or seal. I wouldn't bother personally.

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/