Kawi2strokes.com Forum • View topic - Counter shaft o ring / seal

Board index » Our legendary Kawasaki Triples » Troubleshooting, How-to, and General Wrenching

All times are UTC - 5 hours

Counter shaft o ring / seal

Page 1 of 1

[ 2 posts ]

Print view

Previous topic | Next topic

Author

Message

demus

Post subject: Counter shaft o ring / seal

Posted: Sun Jun 17, 2018 6:20 pm

Joined: Wed Jun 13, 2012 9:00 pm
Posts: 971
Location: Eagle Wisconsin

Ok so now that my H2 leans WAY over on the side stand because of all the mods I have done the counter shaft leaks a bit.
Sitting straight up its fine, no leaks , on the side stand it weeps a bit.
Two questions.
Will this stop if I change the o ring to a new one?

Should I just live with it and clean up the mess once and a while?

The bike rest straight up in the garage so this is only happening when I go out for a ride and leave it parked for a bit. But it dont take much time to start to drip.

I watch the fluids so I am not worried about that either.

Top

Ja-Moo

Post subject: Re: Counter shaft o ring / seal

Posted: Sun Jun 17, 2018 6:40 pm

Site Admin

Joined: Tue Jun 07, 2011 6:37 am
Posts: 10460
Location: Rio Rancho, New Mexico

It's "might", but most likely it's the collar or seal. I wouldn't bother personally.

_________________
Twist the throttle, tilt the horizon, and have a great time. What triples are all about...........

Top

Page 1 of 1

[ 2 posts ]

Board index » Our legendary Kawasaki Triples » Troubleshooting, How-to, and General Wrenching

All times are UTC - 5 hours

Who is online

Users browsing this forum: Bing [Bot]

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: