Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
stock h2 piston ring identification http://www.kawi2strokes.com/forum/viewtopic.php?f=14&t=13316 |
Page 1 of 1 |
Author: | jason8887 [ Sun Mar 04, 2018 2:34 pm ] |
Post subject: | stock h2 piston ring identification |
This is probably covered in another post, but I can't seem to find it. I am trying to determine which of my stock h2 piston rings goes on top. My manual says that the top ring is 'easy to identify because it has chamfered edges and a chromed outer surface'. I call BS, can't tell at all. I have one ring with a couple of markings on the top side of it, the other ring is blank. Any thoughts? |
Author: | jason8887 [ Sun Mar 04, 2018 4:41 pm ] |
Post subject: | Re: stock h2 piston ring identification |
It looks like the bottom ring is the same thickness as the top ring, but the 'width' of the ring is smaller, to accommodate the backup spring. |
Author: | DGA [ Sun Mar 04, 2018 5:16 pm ] |
Post subject: | Re: stock h2 piston ring identification |
There should be no backup spring, as in a 4 stroke oil ring? Not sure on H2 rings, often there is a dot on the top of the top ring. |
Author: | Ja-Moo [ Mon Mar 05, 2018 12:03 am ] |
Post subject: | Re: stock h2 piston ring identification |
It's been forever, but I believe the H2 pistons do have the helper spring ring under the second ring. EDIT looks like it. https://www.ebay.com/itm/KAWASAKI-H2-75 ... rx&vxp=mtr |
Page 1 of 1 | All times are UTC - 5 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |