Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
69 h1 carb problem http://www.kawi2strokes.com/forum/viewtopic.php?f=14&t=13260 |
Page 1 of 1 |
Author: | skaz [ Fri Jan 26, 2018 6:42 pm ] |
Post subject: | 69 h1 carb problem |
cables keep coming out of the slides i have the little butterfly clip in place ?? |
Author: | Ja-Moo [ Fri Jan 26, 2018 8:16 pm ] |
Post subject: | Re: 69 h1 carb problem |
Either they are loose, or you are not sliding them over the insertion hole. |
Author: | skaz [ Fri Jan 26, 2018 8:39 pm ] |
Post subject: | Re: 69 h1 carb problem |
meaning if i adjust the cables completely? |
Author: | Ja-Moo [ Fri Jan 26, 2018 11:22 pm ] |
Post subject: | Re: 69 h1 carb problem |
No the X clip needs to be moved over the install hole. That way the cable can't come out. |
Author: | III [ Fri Jan 26, 2018 11:28 pm ] |
Post subject: | Re: 69 h1 carb problem |
John's talking about the retaining plate (butterfly clip) that you turn to cover the larger insertion hole you fed the cable end through. If its just one slide doing it, pull one of the others out and see what it looks like for an example. |
Author: | skaz [ Sat Jan 27, 2018 12:16 am ] |
Post subject: | Re: 69 h1 carb problem |
i'm doing all of that and know exactly how that works could it be possible that the cable needs to be adjusted before i try and move the slides i've just put the cable on and have not adjusted anything when this happens |
Author: | III [ Sat Jan 27, 2018 6:06 am ] |
Post subject: | Re: 69 h1 carb problem |
Dont see why if the springs are in there to provide tension, how the cables can back out if the retainer plates are over the holes????? Saw an earlier post of yours about throttle rods, they playing any part in slide height? |
Author: | skaz [ Sat Jan 27, 2018 4:26 pm ] |
Post subject: | Re: 69 h1 carb problem |
i seem to have got them working kept doing the same thing the same way and their working ,i think the cable might have been twisted around the idle rod and was slipping out of the butterfly clip on the side that has a small slit anyways ..thanks all!...............skaz |
Page 1 of 1 | All times are UTC - 5 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |