| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| Reversing slide cutaway mod http://www.kawi2strokes.com/forum/viewtopic.php?f=14&t=12919 |
Page 2 of 2 |
| Author: | Hawaii-Mike [ Thu Jun 29, 2017 12:36 am ] |
| Post subject: | Re: Reversing slide cutaway mod |
If you haven't already done so, check with Jim regarding UFO's. He posted earlier on this thread, you can send him a PM or e-mail. |
|
| Author: | usernameandpassword [ Sat Jul 01, 2017 9:38 am ] |
| Post subject: | Re: Reversing slide cutaway mod |
I forget which slides I bought, but I did get some 2.0 slides for a small body and milled the pin channel out. They were mentioned on the resource site, or in a post here somewhere which ones to use.  To get them to fully slide well in the h2 carb, I had to tap the pin back in the carb just a shade to clear. The pin slot is narrower in the slide than the pin in the carb. You can't go too deep as the slide doesn't have enough meat to remove enough to clear the stock pin height.
|
|
| Page 2 of 2 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|