Kawi2strokes.com Forum

Enthusiasts from around the world dedicated to the preservation and ritual flogging of the infamous Kawasaki 2-stroke Triples
It is currently Mon Dec 18, 2017 12:19 am

All times are UTC - 5 hours




Post new topic Reply to topic  [ 12 posts ]  Go to page Previous  1, 2
Author Message
PostPosted: Thu Jun 29, 2017 12:36 am 

Joined: Tue Jul 24, 2012 6:06 pm
Posts: 830
Location: Honolulu
If you haven't already done so, check with Jim regarding UFO's. He posted earlier on this thread, you can send him a PM or e-mail.


Top
 Profile  
 
PostPosted: Sat Jul 01, 2017 9:38 am 
User avatar

Joined: Mon Jun 13, 2011 7:14 pm
Posts: 932
Location: Martinsburg, WV
I forget which slides I bought, but I did get some 2.0 slides for a small body and milled the pin channel out. They were mentioned on the resource site, or in a post here somewhere which ones to use. :think: To get them to fully slide well in the h2 carb, I had to tap the pin back in the carb just a shade to clear. The pin slot is narrower in the slide than the pin in the carb. You can't go too deep as the slide doesn't have enough meat to remove enough to clear the stock pin height.

_________________
74 H2B with reeds and 34mm carbs
75 S3A Ram Air with reeds and 30mm carbs
73 S2A (wife's bike, may keep this one as is)
71 Yammi RT1B
83 HD Sportster
03 Yammi R1


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 12 posts ]  Go to page Previous  1, 2

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
Powered by phpBB® Forum Software © phpBB Group