Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
sticking slides http://www.kawi2strokes.com/forum/viewtopic.php?f=14&t=12911 |
Page 2 of 2 |
Author: | Jim [ Sun Jun 25, 2017 7:57 pm ] |
Post subject: | Re: sticking slides |
jason8887 wrote: I'm not inclined to believe it is a crank seal since I can get it to idle well and the crank has less than 500 miles on a rebuild. I agree, if it's been rebuilt recently, it's probably not crank seals. That's why I asked if it was. |
Author: | demus [ Sun Jun 25, 2017 8:20 pm ] |
Post subject: | Re: sticking slides |
I have found even before I put Jims UFO in that needle clip position at very lean setting affected take off a lot. The transition areas are always the problem. I used this resource a lot when I first was trying to get my jetting right . You Probably already have seen it , but it helped me learn a lot . I was (and still am) realy bad at jetting Good to hear there's been improvement http://kawtriple.com/mraxl/carb/carbadj.htm |
Page 2 of 2 | All times are UTC - 5 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |