| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| H1D grab bar? http://www.kawi2strokes.com/forum/viewtopic.php?f=14&t=12733 |
Page 1 of 1 |
| Author: | DGA [ Sat Apr 29, 2017 6:53 pm ] |
| Post subject: | H1D grab bar? |
The attached pic shows the grab bar I have for my H2B. In the pic it is bolted to the frame at the rear bolt points, so there is a mount point centers difference. I will sell this bar and buy an H2B/C one, but I can't sell this one until I know what it might be for. Any ideas? |
|
| Author: | Stev-o [ Fri Jun 30, 2017 7:10 pm ] |
| Post subject: | Re: H1D grab bar? |
Could be for an H1E [or D?] - I just measured mine and it's 8.25" from the rear mount to the front tip. Is the bar straight between the two mounts? May be interested if reasonable and has good chrome. Thanks |
|
| Author: | DGA [ Fri Jun 30, 2017 11:06 pm ] |
| Post subject: | Re: H1D grab bar? |
It was actually a good bar, and I sold it on Ebay already, sorry. |
|
| Author: | Stev-o [ Sat Jul 01, 2017 10:05 am ] |
| Post subject: | Re: H1D grab bar? |
DGA wrote: It was actually a good bar, and I sold it on Ebay already, sorry. No prob, I have no immediate need just buy good parts when I see em. Did you find the correct bar? |
|
| Author: | DGA [ Sat Jul 01, 2017 9:58 pm ] |
| Post subject: | Re: H1D grab bar? |
I will buy a new repro bar when the budget allows. I realized I need to buy one of Jim's voltage regulators now, as I have an AGM battery, plus I would guess 15 volts from the stock regulator is close to causing problems for these old electronics. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|