| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| freezing water denco pipe fix http://www.kawi2strokes.com/forum/viewtopic.php?f=14&t=12400 |
Page 1 of 1 |
| Author: | H-nube [ Fri Jan 13, 2017 1:54 pm ] |
| Post subject: | freezing water denco pipe fix |
Just tried the freezing water pipe fix on a dented denco pipe and I must say that I am surprised at the results. The dent is 2/3rds removed and looks fairly smooth to the point I'm not going to do any more to it. Thanks members who have posted this technique in the past as it isn't a miracle cure but for a rider bike it works great. |
|
| Author: | H-nube [ Mon Jan 16, 2017 12:28 pm ] |
| Post subject: | Re: freezing water denco pipe fix |
Here is an update. Tried it out on a stinger set last night. I got a small split in one of the seams. I bet the long skinny ends on the stinger froze too quick and there was no safety valve and got a split. Its not bad and the welder will fix it. It did remove about 1/2 the dent on that pipe so its a wash. |
|
| Author: | kawi3cyl [ Wed Jan 18, 2017 12:22 pm ] |
| Post subject: | Re: freezing water denco pipe fix |
How did you freeze these being in SoCal? Did you just fill them with water and leave them outside in the cold? |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|