| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| 74-75 H2 oil passage question http://www.kawi2strokes.com/forum/viewtopic.php?f=14&t=1890 |
Page 2 of 2 |
| Author: | kawi3cyl [ Mon Dec 26, 2011 3:30 pm ] |
| Post subject: | Re: 74-75 H2 oil passage question |
Drill a hole from the cylinder base "vein" to just above the threads in the oil-feed fitting port. If you do it by hand like I did, draw a line on the outside of the port/passage you're preparing to drill with a marker to help guide you visually, so you don't drill crooked like I did with 2 of the 3 holes drilled. 
|
|
| Page 2 of 2 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|