| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| Every Gasket?? http://www.kawi2strokes.com/forum/viewtopic.php?f=13&t=9908 |
Page 1 of 2 |
| Author: | H1Steve [ Sat Jan 31, 2015 7:12 am ] |
| Post subject: | Every Gasket?? |
I am beginning the reassembly process on my motor. I had ordered one of the "every gasket" sets. To my surprise, it does not contain "every" gasket! It does not have the gaskets for the oil passage check valves (Part part number 14051-003) on the bottom of the case   . I just had to cut my own. Not a problem, but kinda pissed me off.
|
|
| Author: | RODH2 [ Sat Jan 31, 2015 8:06 am ] |
| Post subject: | Re: Every Gasket?? |
If you have a later model triple, gaskets are an issue, but Vesrah gasket sets are the best get for a re-build, they are O.E.M. |
|
| Author: | kawi3cyl [ Sat Jan 31, 2015 1:37 pm ] |
| Post subject: | Re: Every Gasket?? |
H1Steve, check your pm for a link I sent you. |
|
| Author: | H1Steve [ Sat Jan 31, 2015 3:34 pm ] |
| Post subject: | Re: Every Gasket?? |
Thanks for the replies. I used the Vesrah kit and was missing these. I've already cut my own and am good to go. I was just frustrated to have to do that when this was the "every" gasket kit. I won't spend more money on another set at this point, but thanks. |
|
| Author: | jyrgNorway [ Sat Jan 31, 2015 4:12 pm ] |
| Post subject: | Re: Every Gasket?? |
It's a "every gasket set" for H2/A, not B/C as far as I know. |
|
| Author: | jyrgNorway [ Sat Jan 31, 2015 4:23 pm ] |
| Post subject: | Re: Every Gasket?? |
Ha. You're absoøutely correct. The marking on my same kit spesifically says H2 1972-1975. |
|
| Author: | Ja-Moo [ Sat Jan 31, 2015 5:16 pm ] |
| Post subject: | Re: Every Gasket?? |
You are not really supposed to take those off, so that's why there are not gaskets in the kits. |
|
| Author: | H1Steve [ Sat Jan 31, 2015 5:23 pm ] |
| Post subject: | Re: Every Gasket?? |
Ja-Moo wrote: You are not really supposed to take those off, so that's why there are not gaskets in the kits. Now you tell me! 
|
|
| Author: | johns02r6 [ Sat Jan 31, 2015 7:21 pm ] |
| Post subject: | Re: Every Gasket?? |
block-off plates perhaps? There you go JA -- start machining! |
|
| Author: | jyrgNorway [ Sun Feb 01, 2015 12:33 pm ] |
| Post subject: | Re: Every Gasket?? |
Ja-Moo wrote: You are not really supposed to take those off, so that's why there are not gaskets in the kits. 
|
|
| Page 1 of 2 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|