Kawi2strokes.com Forum
http://www.kawi2strokes.com/forum/

Base gasket?
http://www.kawi2strokes.com/forum/viewtopic.php?f=13&t=5336		 Page 1 of 1
Author:  mvent [ Thu Jan 03, 2013 7:53 pm ]
Post subject:  Base gasket?
Ready to assemble H1B top end, base gasket dry or with some kind of dressing?Gaskets are Vesrah.
TIA
Author:  two-stroke-brit [ Thu Jan 03, 2013 8:25 pm ]
Post subject:  Re: Base gasket?
i used copper seal on both faces of the gasket ,
should come apart easier next time.
Author:  Jim [ Thu Jan 03, 2013 8:57 pm ]
Post subject:  Re: Base gasket?
I use a little sealer on one side and anti-seize on the other because I like to reuse them a few times when removing the jugs for decarboning the rings, etc.. But let your preference dictate.
Author:  Looney Cylinders [ Thu Jan 03, 2013 9:12 pm ]
Post subject:  Re: Base gasket?
What ever sealant/compound you decided on keep it WELL away from the oil injection hole that leads to the intake port. I have a bottom end that the PO clogged the hole with RTV. It had a rod break and smash the case! :o :o

J
Author:  Ja-Moo [ Thu Jan 03, 2013 9:29 pm ]
Post subject:  Re: Base gasket?
anti-seize both sides, actually acts as a sealer, but gaskets peel right off. As was posted, don't fill the oil hole. Thin layer rubber in, is all you need.
Author:  mvent [ Thu Jan 03, 2013 9:36 pm ]
Post subject:  Re: Base gasket?
Ja-Moo wrote:
anti-seize both sides, actually acts as a sealer, but gaskets peel right off. As was posted, don't fill the oil hole. Thin layer rubber in, is all you need.

Anti seize huh?As in the stuff you put on spark plug threads?Never would have thought it,thanks guys.
Author:  Ja-Moo [ Thu Jan 03, 2013 11:12 pm ]
Post subject:  Re: Base gasket?
That's it, stink and all....
Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/