Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
All Balls Tapered Bearings http://www.kawi2strokes.com/forum/viewtopic.php?f=13&t=14784 |
Page 1 of 1 |
Author: | Goodwrench [ Sat Jan 07, 2023 12:28 pm ] |
Post subject: | All Balls Tapered Bearings |
Just wondering if anyone has any tips for the installation of the All Balls tapered roller bearings in a H2? Looks like removing the tapered roller bearing outer race from the head stock after installation would be a challenge. Hoping I never have to tackle that but has anyone ever ground notches in the inner diameter of the head stock to allow a punch to catch the outer race? Or would that weaken the head stock? Any comments or general advice would be appreciated. I've watched a half dozen YouTube vids on the subject. |
Author: | Never2Old [ Sat Jan 07, 2023 4:31 pm ] |
Post subject: | Re: All Balls Tapered Bearings |
I replaced mine with no problem. I used a long drift to tap the race out from the opposite end, both upper and lower races. IIRC there are a couple of small indentations on both sides allowing the drift to rest on the back side of the races. Dave |
Author: | BarryB [ Sun Jan 08, 2023 7:21 am ] |
Post subject: | Re: All Balls Tapered Bearings |
Never2Old wrote: I replaced mine with no problem. I used a long drift to tap the race out from the opposite end, both upper and lower races. IIRC there are a couple of small indentations on both sides allowing the drift to rest on the back side of the races. Dave Same here, I used a large rubber washer for the headlight ear slack. |
Page 1 of 1 | All times are UTC - 5 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |