Kawi2strokes.com Forum

Enthusiasts from around the world dedicated to the preservation and ritual flogging of the infamous Kawasaki 2-stroke Triples
It is currently Fri Mar 29, 2024 8:50 am

All times are UTC - 5 hours




Post new topic Reply to topic  [ 5 posts ] 
Author Message
 Post subject: torque specifications
PostPosted: Sun Jan 29, 2017 2:19 pm 

Joined: Sat Jan 28, 2012 6:23 pm
Posts: 96
Location: Springfield,Ma.
I looked on Maxrl's resource page and didn't see these listed. What is the torque specs for the clutch basket nut & the oil pump gear drive nuts, both the small one and the large?

_________________
Mike
________________________
1995 Yamaha Vmax VMX12G
1974 Kawasaki H2 750
1986 Kawasaki KDX200
________________________


Top
 Profile  
 
PostPosted: Sun Jan 29, 2017 3:55 pm 
User avatar

Joined: Tue Jan 17, 2017 6:02 am
Posts: 95
Location: Helensburgh Australia
In the torque table under clutch I'm assuming HUB NUT is the large nut for the clutch basket, which is 115Nm (70ft/lb old school)

_________________
Cheers Baz.
“I refuse to answer that question on the grounds that I don't know the answer”

1973 H2-A
2000 F650GS BMW


Top
 Profile  
 
PostPosted: Sun Jan 29, 2017 5:12 pm 
Site Admin
User avatar

Joined: Tue Jun 07, 2011 6:36 am
Posts: 2691
Location: Dandridge, TN, USA
http://kawtriple.com/mraxl/torque.html

_________________
Answers are here: http://kawatriple.com/


Top
 Profile  
 
PostPosted: Tue Jan 31, 2017 6:02 am 

Joined: Sat Jan 28, 2012 6:23 pm
Posts: 96
Location: Springfield,Ma.
Yup. Missed the clutch nut right there in front of me.......What about the the other two for the oil pump. Chart only lists the bajno bolts? I thought I saw in another thread I searched out that the small bolt is 5 lbs in?

_________________
Mike
________________________
1995 Yamaha Vmax VMX12G
1974 Kawasaki H2 750
1986 Kawasaki KDX200
________________________


Top
 Profile  
 
PostPosted: Tue Jan 31, 2017 7:16 am 
Site Admin
User avatar

Joined: Tue Jun 07, 2011 6:36 am
Posts: 2691
Location: Dandridge, TN, USA
If the specific bolt is not specified use the general tables. Not sure what two bolts you are referring to but 5 in/lb would be finger tight.

_________________
Answers are here: http://kawatriple.com/


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 5 posts ] 

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group