| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| torque specifications http://www.kawi2strokes.com/forum/viewtopic.php?f=13&t=12443 |
Page 1 of 1 |
| Author: | grnh2750 [ Sun Jan 29, 2017 2:19 pm ] |
| Post subject: | torque specifications |
I looked on Maxrl's resource page and didn't see these listed. What is the torque specs for the clutch basket nut & the oil pump gear drive nuts, both the small one and the large? |
|
| Author: | BazNSW [ Sun Jan 29, 2017 3:55 pm ] |
| Post subject: | Re: torque specifications |
In the torque table under clutch I'm assuming HUB NUT is the large nut for the clutch basket, which is 115Nm (70ft/lb old school) |
|
| Author: | mraxl [ Sun Jan 29, 2017 5:12 pm ] |
| Post subject: | Re: torque specifications |
http://kawtriple.com/mraxl/torque.html |
|
| Author: | grnh2750 [ Tue Jan 31, 2017 6:02 am ] |
| Post subject: | Re: torque specifications |
Yup. Missed the clutch nut right there in front of me.......What about the the other two for the oil pump. Chart only lists the bajno bolts? I thought I saw in another thread I searched out that the small bolt is 5 lbs in? |
|
| Author: | mraxl [ Tue Jan 31, 2017 7:16 am ] |
| Post subject: | Re: torque specifications |
If the specific bolt is not specified use the general tables. Not sure what two bolts you are referring to but 5 in/lb would be finger tight. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|