Three Pipes, you know some stuff.
| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| spark plug wires http://www.kawi2strokes.com/forum/viewtopic.php?f=13&t=10841 |
Page 1 of 1 |
| Author: | LIRUSS [ Sun Aug 16, 2015 7:18 pm ] |
| Post subject: | spark plug wires |
gotta replace my miss matched wires, what & where do you guys get your wires from ????? |
|
| Author: | ThreePipesSmokin [ Mon Aug 17, 2015 6:46 am ] |
| Post subject: | Re: spark plug wires |
Lots of people buy a V8 kit from the auto parts store and get 2 sets out of it, just be sure to get solid core wires and non resistor caps. (for stock ignitions) I like the original look and buy the set from HVC Cycle. http://www.hvccycle.net/ignition-coil-wire-kits/ |
|
| Author: | Iron [ Mon Aug 17, 2015 8:03 am ] |
| Post subject: | Re: spark plug wires |
Three Pipes, you know some stuff.
|
|
| Author: | LIRUSS [ Mon Aug 17, 2015 8:56 am ] |
| Post subject: | Re: spark plug wires |
awesome.... exactly what i was looking for !!!!! thanks |
|
| Author: | Brian H. [ Tue Aug 18, 2015 7:47 pm ] |
| Post subject: | Re: spark plug wires |
If you can't find automotive solid core wires, buy a set for a tractor. |
|
| Author: | LIRUSS [ Wed Aug 19, 2015 9:14 am ] |
| Post subject: | Re: spark plug wires |
thanks Brian , but i live on Long Island NY...no one even knows what a tractor is here ! LOL |
|
| Author: | mc356ce [ Thu Aug 20, 2015 9:17 pm ] |
| Post subject: | Re: spark plug wires |
Parts Unlimited sells the wire on a roll, it is the tractor type stuff. |
|
| Author: | BBP [ Fri Sep 04, 2015 1:27 pm ] |
| Post subject: | Re: spark plug wires |
Liruss On my H2B..........you can dig the "hump" off of the coil's with a hack saw blade and pry it off, it is a peice of rubber that is epoxied........then there is a "post" to re-solder the new wire to........I used 7mm fine stranded auto type wire, 4 feet (as electrons travel on the surface of wire, not thru it.........stranded flows more current)........I then got the very nice NGK non-resistor 90 degree caps.........put the rubber hump back on the coil and re-epoxy...........get some red model paint and re-paint the coils..........took maybe 3 hours tops.......bet very nice and no splicing (I think this is only on H2's, not sure though) I also run a zeeltronic iggy.........it has a strong blue spark.........I had to use iridium resistor plugs in that setup.......you won't THX Phil 
|
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|